Launching Your Inboard Boat - Nuts & Bolts Pro Tip

ADVERTISING

LuxoGear Emergency Whistles with Lanyard

Shop now »

NOCO Genius GEN5X2, 2-Bank, 10A (5A/Bank) Smart Marine Battery Charger

Shop now »

RHINO USA Boat Trailer Transom Straps (2PK)

Shop now »

LUCKY Kayak Portable Fish Depth Finder

Shop now »

Seaview 180 V3 Full Face Snorkel Mask

Shop now »

Most popular comments
for Launching Your Inboard Boat - Nuts & Bolts Pro Tip

Live comments
Comments on YouTube

Donald - 6 years ago

The ramp is for unloading and loading the boat, NOT checking oil, belts, etc. Literally, offloading should take 2 minutes on the ramp, loading maybe 5. The towing vehicle is a stop and go float off after the boat motor was fired up at home with water running through the pumps. Easier to fix probs in the garage than in a parking lot.

UNDERGROUND WHEREHOUSE - 6 years ago

Don’t dilly dally... just check your oil and throw in a fresh serpentine belt

Where’s Christopher - 7 years ago

check your tampon.

Keith Williams - 7 years ago

While your on the ramp " dilly-dallying" with the dip stick checking your oil, go ahead and tell the wife to throw all the inflatable towable water toys on the ramp and blow them up with the portable air compressor. Have her check the tires on the trailer while she's at it and give them a shot of air. The five guys waiting in line to launch won't mind since this is their only lake day available for the next three weeks....

Jacob Freedman - 7 years ago

Make sure you unwind the wench VERY SLOWLY!!!! Fucking morons!!!!!

olebiker - 7 years ago

Jacob Freedman You have a wench on your boat? Hope your Wife doesn't find out about her. The word is winch.

DrewT - 7 years ago

No worries. Take your time on the ramp. After you check oil, belts & hoses go ahead and pull your spark plugs to evaluate for rich/lean & gap them all. Be sure to do compression checks on all cylinders, pull out your timing light & check timing too. Also, be sure to pull a sample of your v-drive fluid. Go ahead and send it off to the lab. We'll wait until it comes back. Heck, while we're waiting go ahead and lube your steering & throttle cables. Might as well replace that burned out courtesy light while your at it...

ADRIAN GLOVER - 7 years ago

No idea why they spent the first 5 mins explaining how to make sure the prop and rudder is protected, only to say that there is a guard that does all that"

Floyd Burdett - 6 years ago

They were addressing the issue for those who do NOT have such a trailer, as well as being mindful of the issue in shallow water or on shallow-angle ramps.

M&D Mile Inc - 7 years ago

I think this video should be how not to launch boat.. :))

vampov - 8 years ago

4:15 That's a good point. I love watching people launch their boats without making sure it starts.

10. comment for Launching Your Inboard Boat - Nuts & Bolts Pro Tip

Runamuck - 8 years ago

inboard outboard cant say ive heard of that term b4.. stern drive i have

Floyd Burdett - 6 years ago

Inboard engine...Outboard drive unit ... I/O or inboard/outboard...
Stern-drive ... Drive Unit mounted on the stern... They both sort of say the same thing, BUT you could have various Different types of drive units that attach to the stern, or outboard of the boat...

Stan M - 7 years ago

Inboard outboard is the original term used when they were designed in the early 60's. That is still the correct term to be used today. I guess for some reason today like everything else people want to be politically correct so they say sterndrive.

HOOLIGANfilmz - 8 years ago

have you heard the term, i/o ? inboard/outboard.

Steve just Steve - 8 years ago

You do any stupid shit like checking your oil on the ramp and I'm going to back over your ass. THE WORST ARE THE IMBOSOLS THAT BACK UP ALL CADDYWOMPAS ON A 3 BOAT RAMP OR DOWN THE MIDDLE OF A 2 BOAT RAMP AND TAKE THE WHOLE THING UP!!!!

clark hall - 8 years ago

Best way to launch an inboard is back up quick and deep with all the straps removed and let it drift off the trailer. If you power unload it you will be going through carpet once a season. Inboards way to much and chew through carpet quick. Same thing when loading back trailer in deep so your boat barely touches the carpet.

Tom Smith - 6 years ago

clark hall your right I power load bc it's just me , brand new boat bunks half wore out 15 loads .....gonnac buy best carpet known to man lol

Super Dave - 8 years ago

Even a novice would know to check oil level . belts and hoses in the staging area.....before putting it in the water.

josh summers - 8 years ago

I was thinking the same thing

Crazykid02 - 8 years ago

I have that same boat just its an rc

hewitt52 - 8 years ago

Yeah, because someone checking oil, belts, and hoses on the ramp won't piss off the others waiting to use the ramp...

Jeremy Busch - 6 years ago

It’s best to check the oil in the prep lane that way you won’t piss people off taking up the lane

Jacob Freedman - 7 years ago

hewitt52 totally agree, how about check the oil at the prepare ramp and check the motor health when at the dock

Regal2800 - 8 years ago

+hewitt52 That and it's best to check oil level while the boat is on a level surface, not while it's on an incline.

T/D T/S - 9 years ago

hey my malibu is way prettier like black and yellow what are yall whiz khalifia

Alan Hewett - 9 years ago

Where is u helmet, grandma ? Bow hook is off mine at the top of the ramp, stomp on the brakes just at the right time.

Floyd Burdett - 6 years ago

Good luck with that 'launch method'... stomp the brakes on a steeper ramp...and you could use your cell phone to call a towing company to pull your vehicle out of the lake.
Lots of things that can go wrong with that method, and even damaging your boat, trailer, and/or vehicle..and spill or lose overboard items inside your boat...

Josh Whitaker - 9 years ago

True, make sure it will run before you release the boat. False, you check things on the engine while on the ramp. You don't check a damn thin on the ramp. You do that stuff else where and not in everybody else's way

sysinu - 10 years ago

lol... Let's check our oil on the boat ramp. If you're taking longer than a minute to launch your boat, you're doing something wrong.

20. comment for Launching Your Inboard Boat - Nuts & Bolts Pro Tip

Big Vern Hoffman - 10 years ago

What about unplugging your trailer before, to ensure you don't short out the trailer lights?

truenorthcanada - 10 years ago

You got to be kidding "check your hoses and oil" LOL you must be making lots of friends where you launch

Glenn Sullivan - 11 years ago

btw I have a Nautique with bunk trailer. (don't loosen the bow strap on a roller trailer ) Loading it is the reverse. As the trailer backs in I idle the boat in drive it on the bunks. Turn it off, go to the bow, hook the bow strap, crank it up snug and give the driver the go signal. Target under a minute from the time the trailer hits the water to when it is out. I have it down to a science. best times are les than 30 sec trailer in the water.

Glenn Sullivan - 11 years ago

Before leaving the house do your coastguard safety check and check your oil, belts, plugs ect. Test start the boat a the house. At the staging area turn it over for 1 sec, to make sure it will start. Remove the rear tie downs and loosen the front bow strap a few inches . Back down the ramp, I am in the bow, once in the water all I do is lean over the front, release the bow hook then go back the boat off the trailer. I target less than 1 min with the trailer in the water. Some are under 30 sec

Jef Horians - 11 years ago

You're so right. He better even checked the oil when he picked up the boat.

Dustin Whiteman - 7 years ago

Boat trailer

seadoorider7 - 12 years ago

He should highlight the part of doing it quickly! if only more people would know that

Timmy Sienna - 12 years ago

He forgot about his 10 yo son who went into the water and is playing with the propeller

rinski73 - 12 years ago

float on trailer that is not i really dont think anyone should take this advise you dont check you oil with the boat on an angle or while your setting on the ramp blocking everyone else

fahadcomcom - 12 years ago

4:37 are u still recording !!!! looool

Jroracing - 12 years ago

That was a v drive boat

Floyd Burdett - 6 years ago

V-Drive is still an Inboard set-up...all of the engine, transmission, and drive components are Inside the boat... whether a V-Drive or a Direct-Drive arrangement... (smile)

30. comment for Launching Your Inboard Boat - Nuts & Bolts Pro Tip

Theknotman1964 - 12 years ago

Should've checked all the all oil levels and fuel levels before you launched the boat Your just holding up all the other people that want to use there boats

Lj rider - 12 years ago

and he is on an angle so it wont b a good reading

emitchsr - 12 years ago

I like to hold my foot on the brake with left foot and start accelerating with right foot while taking left foot off of the brake when taking the trailer out of the water that way the truck doesn't roll backwards and start going toward the water. Especially when to boat is loaded.

BOSS MAN - 12 years ago

I always do all my checks and start the engine while im still home, i let it run for few minutes and also put the plug in at this time..... I disagree with what this guy said on this video to check the oil on the ramp, the motor is at an angle and will give you a false reading on the dip stick... the boat/motor needs to be on level ground to check the oil!!!!!

DrizzyDraketheman13 - 12 years ago

Nice Boat

Dustin Whiteman - 7 years ago

DrizzyDra

Boat trailer

richie rich - 12 years ago

7 bucks thats a crazy price

Bobsackamanno's_Dad - 12 years ago

I just like the fact that this guy used the expression "dilly dally".

Canadian Fishing - 12 years ago

EVERYONE CHECK OUT MY CHANNEL PLEASE

G Sneed - 12 years ago

Getting on & off the ramp quickly is so very important to be considerate of others. Get your stuff together in the STAGING AREA. Two points of disagreement with the video: 1, Checking the oil, and opening up the engine box to sniff around. You check your oil before you leave the house. 2, You should have the bilge blower on from the time u board, all the way down the ramp and into the H2O. Do check your stuffing box & bilge area once the motor has been started for wata! Good video, and Thanks!

gfsugar2plus - 12 years ago

@enterprise59 I agree with that - especially when you're alone. But I have seen people take up two launch positions, do repairs on the boat on the ramp, stop half way up the ramp and start to empty the boat, and all kinds of inconsiderate behaviour. I sat on the lake for one hour one day waiting to get off. That is frustrating.

sho942000 - 13 years ago

Good video. Being a new owner to an inboard, I was amazed at how different launching, etc really is from a traditional outboard/inboard-outboard boat. 25+ years of those did not prepare me for a true inboard. But like the video says...take it slow and easy and you'll be fine. don't try to launch for your first time on a busy day...practice first.

NIGHTRIDER995 - 13 years ago

@butane8 video ended...lmao

butane8 - 13 years ago

ill nodded off after dilly dally,, what happened

dogbyte555 - 13 years ago

How about checking the oil before you get to the ramp so maybe some one else can use the ramp today too.

About Launching Your Inboard Boat - Nuts & Bolts Pro Tip

The "Launching Your Inboard Boat - Nuts & Bolts Pro Tip" video is part of the boating, sailing tipps category, which contains similar videos like this one.